Repository
MMX
Un percorso completo da zero ad un setup Klipper multicolore funzionante: file, distinta base, assemblaggio hardware, cablaggio, configurazione Happy Hare, calibrazione, prima stampa e supporto.
v1.0AttivoPacchetto release finaleKlipper
4 gateConfigurazione gate documentata
Type-AArchitettura selettore servo
EBB42Scheda di cablaggio di riferimento
Happy HareSoftware Klipper MMU
BOM
Reference list based on the MMX build manual. Prices and links can change, so treat this as a structured checklist and keep the official kit/download page as the latest source.
| Part | Qty | Notes |
|---|---|---|
| Endstop switches | 4 | Pre-gate filament detection |
| GT2 belt 6mm x 184 | 1 | Belt listed in MMX manual BOM |
| GT2 belt 6mm x 188 | 1 | Belt listed in MMX manual BOM |
| F695 bearings | 5 | Gate/idler bearing positions |
| 685 bearings | 3 | Bearing listed in MMX manual BOM |
| F623 bearings | 2 | Bearing listed in MMX manual BOM |
| BMG gear kit | 5 | Filament drive/idler gear parts |
| 134mm 5mm OD shaft | 2 | Main shaft lengths from manual |
| 107mm 3mm OD shaft | 1 | Idler door shaft from manual |
| 108mm M3 threaded rod | 2 | Gate stack alignment rods |
| NEMA 17 stepper | 1 | Gear stepper |
| MG996 servo | 1 | Selector/camshaft servo |
| 20T pulley 5mm OD | 2 | Stepper and T80 drive |
| Heat-set inserts | 20+ | M3 inserts used across printed parts |
| BTT EBB42 | 1 | Reference board used by the wiring guide |
| ECAS04 connectors | 8 | PTFE tube connections |
| 6x3 N35 magnets | 8 | Gate/idler magnets; orientation matters |
| 5mm steel balls | 4 | Gate switch actuation |
| Binky encoder | 1 | Listed in the manual BOM |
Kit option
The manual and project page mention a tested kit with the required hardware. It does not include printed parts.